Wiring-ready sliding pocket door system for single door

Lets you change the door size without removing the door panel.

As it crosses the pocket door in all its width, it permits to solidly link the pocket with the stop jambs, thus making the assembly easier.

Made of coupled metal sheet and wood; the steel avoids any problems of deformation, while the wood facilitates the application of the jamb to the upright.

If required, it is possible to install up to 10 electrical boxes in each panel (5 on one side and 5 on the other).

Works on the same opening principle as cans: the base of the counterframe is removed to make the most of the space below when there is a difference in height between the counterframe installed and the finished floor.

This is quickly applied directly to the counterframe with no need to drill the floor.

Made of doubled-up metal sheet, bent so that they form a single body with the solid wall. They ensure greater resistance in what would otherwise be a weak point in the counterframe where cracks in the plaster could begin to form, as it is the furthest point from the wall studs.

16 horizontal bars attached to the plasterholding mesh lends great resistance and rigidity to the counterframe, so that it can effectively counter the tension generated by brickwork and solid walls. Robustness is fundamental as the frame effectively replaces a portion of the wall. There are 32 bars with double leaf.

Thickness 0.7 mm. The bosses are reliefs that prevent any deformation in the sheet. They are a guarantee of great robustness and rigidity.

They guarantee long lasting, smooth and silent action. Standard door’s weight is 100 Kg.

It is always possible to substitute worn mechanisms and to add accessories.

For joining the overboarding mesh to the counterframe: avoids the onset of rusting and potential detachment from the mesh.

It joins the counterframe (50x25 mm) with the wall becoming an integral part of it, thus offering an increasing grasp of the laster. The finished wall won’t have faults.

Lets you change the door size without removing the door panel.

As it crosses the pocket door in all its width, it permits to solidly link the pocket with the stop jambs, thus making the assembly easier.

Galvanised steel channel where to insert electrical wiring, equipped with earth cable.  

This is quickly applied directly to the counterframe with no need to drill the floor.

Made of doubled-up metal sheet, bent so that they form a single body with the solid wall. They ensure greater resistance  to lateral pressures.

Made of coupled metal sheet and wood; the steel avoids any problems of deformation, while the wood facilitates the application of the jamb to the upright.

12 for the stud wall version made in 7/10 galvanized steel, with a dovetail form which grant an increased strength to lateral pressures (in order to have an un-deformable internal passage). There are 24 bars with double leaf.

It is always possible to substitute worn mechanisms and to add accessories.

Horizontal bar made of metal (rather than wood or PVC) increases the robustness against increased load from above.

They guarantee long lasting, smooth and silent action. Standard door’s weight is 100 Kg.